СКУ: 48750
Товаров прекъсвач Masterpact NW25HA10 - 2500 A - 1150 V - 3 полюса - изваждащ се
-
Brand
Schneider Electric
-
Type of electrical connection of main circuit
EV000415
-
Version as emergency stop installation
FALSE
-
Version as reversing switch
FALSE
-
Number of poles
3
-
Version as safety switch
FALSE
-
Suitable for distribution board installation
FALSE
-
Number of switches
1
-
Motor drive integrated
FALSE
-
Suitable for intermediate mounting
FALSE
-
Suitable for front mounting centre
FALSE
-
Version as main switch
TRUE
-
Interlockable
TRUE
-
Version as maintenance-/service switch
TRUE
-
Colour control element
EV000206
-
Suitable for front mounting 4-hole
FALSE
-
Suitable for floor mounting
TRUE
-
Rated short-time withstand current lcw
50
-
Rated permanent current Iu
2500
-
Motor drive optional
TRUE
-
Type of control element
EV000554
-
Device construction
EV009210
-
Number of auxiliary contacts as change-over contact
5
-
Voltage release optional
TRUE
-
Degree of protection (IP), front side
EV006410
-
Rated permanent current at AC-23, 400 V
2500
-
Number of auxiliary contacts as normally closed contact
-
Number of auxiliary contacts as normally open contact
-
Max. rated operation voltage Ue AC
1150
-
Rated operating voltage
1150
This accessory belongs to the Vigilohm range designed to monitor ungrounded/IT electrical networks at feeder level, in accordance to installation and products standards. This part is a surge limiter used on IT networks, and installed as close as possible to the medium to low voltage transformer. They protect ungrounded networks from overvoltages that might be caused by transformer breackdown or lighting strikes. This Cardew C is to be installed on a monitored network of 660V AC to 1000V AC when connected between phase and neutral. Or 380V AC to 660V AC if the Cardew C is connected between two phases. It is recommended to monitor the cardew with an insulation fault locator such as the Vigilohm family IFL12. So that an insulation fault due to the cardew can be immediately identified, and its cartridge replaced. The dimensions of this limiter are 160mm in length, and 70mm in diameter, for a product weight of 1 kilogram.
Similar
Products
Recently viewed